Delta Pulse 2

[mazari]

can anyone help?
Linkback: Ynt: Delta Pulse 2

[Karadağ]

Can you  add a few high quality pictures examine from circuit.

[mazari]

je vous remercie beaucoup.

[mazari]

delta

[mazari]

delta posrteure3

[mazari]

delta4

[mazari]

delta5

[Karadağ]

Your job is so hard! Your PCM is not good. You have to measure all tracks.

[mazari]

thank you for your help.

[onur600]

Devrenin çalismasi mucize.Lehiler kötü ve temizliği yapılmamış.

[mazari]

thank you for your reply.xow i have cleaned the board .it's clear there is no contact between lines but i have the same problem very poor detection i could get the maximum distance was 10 cm .please can you help me?

[mazari]

d1

[mazari]

d2

[mazari]

d3

[onur600]

Okey.
Install 356 on the LF357. Remove the 2k2 damping resistor and connect 680r 2w. Short circuit PR1.
Battery 12v 2.5a minumum.

[mazari]

my coil is 36cm diameter .[/size] 32turns 0.5mm which measure 3.4 ohms dc resistance.damping resistor:680ohm 1watt frequency 140hz

[onur600]

Ok.
Now make fl357 fl356.

[mazari]

S'il vous plaît, j'ai une question: lorsque je mesure la sortie à la broche 9 de lm556, j'ai: 0.2 à 0.3 volts. Et la sortie à la pin6 de lf357, je reçois: 1.2volt. Vous pensez être la bonne tension? Merci d'avance

[mazari]

S'il vous plaît, j'ai une question: lorsque je mesure la sortie à la broche 9 de lm556, j'ai: 0.2 à 0.3 volts. Et la sortie à la pin6 de lf357, je reçois: 1.2volt. Vous pensez être la bonne tension? Merci d'avance

[onur600]

Distance problem lf 357,357 potatoe